Please Help!

[Sennarx]

Hi!

By mistake I replaced Dolph Ziggler with another wrestler: can I restore Ziggler?

 

Edited November 16, 2018 by Sennarx

[Cave Waverider]

You can find his original .pofo and .moveset files in Data Editor's Templates folders. Inject those and they should be restored.

If you were wise and installed .pac files with his Wrestler ID in the mods folder, all you'll have to do is delete those files and regenerate the Chunk0.def file.

If you've replaced Ziggler's original .pac files, however, you'll have to backup your mods and let Steam verify the game files, then restore the rest of your mods. Unless you've created a backup of your game folder before modding, in which case you'll just have to copy Ziggler's .pac files over.

In the future, if you haven't done so yet, make sure to install all your mods in the \mods sub-folder instead of replacing files, it'll make it easier to go back to the originals.

[Sennarx]

Thanks, now I try! However I did not replace the original file, but I modified the hex following the memory sheet: I put D-Von Dudley on slot 275, which seemed free.

[Cave Waverider]

You need to be careful. The Slot is not the same as the Wrestler ID. You have to check the column for the Wrestler ID. D-Von's Wrestler ID on the Memory sheet would be 478. Dolph Ziggler's is 275.

That said, since you didn't replace anything, all you'll have to do is change the ID inside the .pac files to 478 instead of 275. You'll have to inject .pofo and .moveset, with Wrestler ID 478 for D-Von as well.

[Sennarx]

Thanks a lot! I solved the problem! I looked at the slot column and not the ID column. Thank you!
For now the only one I replaced is Cole Quinn with Rhodes (All In). In the future I will eventually replace the doubles (Daniel Bryan, Bray Wyatt etc.).

A question: is there a mod to increase the difficulty?

Edited November 16, 2018 by Sennarx